Iris & Warm Musk Fragrance Oil

Floral and woody with iris, vetiver, cedarwood, orange blossom, musk, benzoin, and frankincense undertones. Top notes: orange blossom, mandarin. Heart: iris, vetiver, cedarwood. Base: musk, benzoin, frankincense.

Use 5–10% of the candle’s total weight. For a 200g candle that’s 10–20g of Iris & Warm Musk (about 10–19ml). There is no IFRA limit for candles. The calculator above works it out for any size.

Use 5–10% – that’s 5–10g of fragrance oil for every 100g of finished melts. Check the maximum your wax can hold.

Possibly. The IFRA maximum is 17.14%. Some oils give a good scent throw at this level and some don’t, so test a small batch in a reed diffuser base such as Augeo Clean Multi before a full run. Ready-made reed diffuser CLP labels and an SDS are in the documents above.

• Soap: yes – 3–6% (IFRA maximum 17.14%)
• Body lotion: yes – 0.5–1.5% (IFRA maximum 33.58%)
• Face cream: yes – 0.1–0.5% (IFRA maximum 4%)
• Perfume: yes – 5–20% (no IFRA limit)
• Lip balm: not suitable

Soap, lotion and perfume are cosmetics, so each one needs a safety assessment (CPSR) before you sell it.

Undiluted, Iris & Warm Musk is classified under GB CLP with the signal word Warning:

• H315 Causes skin irritation.
• H317 May cause an allergic skin reaction.
• H411 Toxic to aquatic life with long lasting effects.

Candles, wax melts and diffusers you make with it may need their own CLP label. Full details are in the Safety Data Sheet.

No. Its flash point is >100°C, so it isn’t classified as flammable. Like any fragrance oil, keep it away from naked flames.

It’s unlikely. Iris & Warm Musk contains no vanillin or ethyl vanillin, the most common cause of discolouration. Always test with your own wax and dyes.

Yes. Our free CLP label creator makes a ready-to-print label for candles and wax melts made with Iris & Warm Musk, and for reed diffusers. Safety Data Sheets, IFRA certificates and label files are in the documents above.

Yes. All are 100% vegan with no animal-derived ingredients.

Yes.

• Electric water diffusers (ultrasonic or humidifier style) – fill the tank with water to the line, then add 3–5 drops per 100ml of water. Start low and add more to taste.
• Oil burners – mix 50/50 with dipropylene glycol (DPG), or add a few drops to water in the well.

Important – look after your diffuser:

• Fragrance oils are concentrated, and some plastics used in diffuser tanks can soften, cloud or crack if oil is left sitting in them. This depends on the plastic the diffuser is made from. It happens with any concentrated fragrance or essential oil, not just ours.
• Empty the tank when you’ve finished. Don’t leave water and oil sitting in it between uses.
• Rinse and wipe the tank every few uses, as fragrance oils can leave a film.
• Check your diffuser’s instructions to make sure it is suitable for fragrance oils. If it says essential oils only, or doesn’t say, ask the maker before using it.

They include a blind plug to prevent leaks in transit. Either pierce the centre with a pin or biro to use it as a dropper, or remove the stopper, pour, and replace the plug.