Crystal Edge Fragrance Oil

Fresh-woody with bergamot, pepper, cedarwood, cocoa, amber, and musk. Top notes: bergamot, pepper. Heart: cedarwood, cocoa. Base: amber, musk. It’s inspired by a well-known designer fragrance – see which one in our designer dupe chart.

Use 5–10% of the candle’s total weight. For a 200g candle that’s 10–20g of Crystal Edge (about 10–20ml). There is no IFRA limit for candles. The calculator above works it out for any size.

Use 5–10% – that’s 5–10g of fragrance oil for every 100g of finished melts. Check the maximum your wax can hold.

We don’t recommend it. The IFRA maximum for reed diffusers is only 10%, which is too low for a good scent throw.

• Soap: yes – 3–6% (IFRA maximum 10%)
• Body lotion: yes – 0.5–1.5% (IFRA maximum 7.87%)
• Face cream: yes – 0.1–0.5% (IFRA maximum 0.87%)
• Perfume: yes – 5–20% (IFRA maximum 57.57%)
• Lip balm: not suitable

Soap, lotion and perfume are cosmetics, so each one needs a safety assessment (CPSR) before you sell it.

Undiluted, Crystal Edge is classified under GB CLP with the signal word Warning:

• H315 Causes skin irritation.
• H317 May cause an allergic skin reaction.
• H319 Causes serious eye irritation.
• H410 Very toxic to aquatic life with long lasting effects.

Candles, wax melts and diffusers you make with it may need their own CLP label. Full details are in the Safety Data Sheet.

No. Its flash point is 90°C, so it isn’t classified as flammable. Like any fragrance oil, keep it away from naked flames.

It’s unlikely. Crystal Edge contains no vanillin or ethyl vanillin, the most common cause of discolouration. Always test with your own wax and dyes.

Crystal Edge is inspired by a well-known designer fragrance. Find out which one in our designer dupe chart.

Yes. Our free CLP label creator makes a ready-to-print label for candles and wax melts made with Crystal Edge. Safety Data Sheets, IFRA certificates and label files are in the documents above.

Yes. All are 100% vegan with no animal-derived ingredients.

Yes.

• Electric water diffusers (ultrasonic or humidifier style) – fill the tank with water to the line, then add 3–5 drops per 100ml of water. Start low and add more to taste.
• Oil burners – mix 50/50 with dipropylene glycol (DPG), or add a few drops to water in the well.

Important – look after your diffuser:

• Fragrance oils are concentrated, and some plastics used in diffuser tanks can soften, cloud or crack if oil is left sitting in them. This depends on the plastic the diffuser is made from. It happens with any concentrated fragrance or essential oil, not just ours.
• Empty the tank when you’ve finished. Don’t leave water and oil sitting in it between uses.
• Rinse and wipe the tank every few uses, as fragrance oils can leave a film.
• Check your diffuser’s instructions to make sure it is suitable for fragrance oils. If it says essential oils only, or doesn’t say, ask the maker before using it.

They include a blind plug to prevent leaks in transit. Either pierce the centre with a pin or biro to use it as a dropper, or remove the stopper, pour, and replace the plug.